Table of Contents
Advertisement
Installation and Setup
Installation and Setup
The following procedure provides instructions for setting up the BluStar 8000i terminal, and for connecting it to your net-
work.
1.
Carefully remove the BluStar 8000i components from their shipping container and place them on a clean, flat, dry
surface (typically a desktop).
2.
Connect one end of the handset cable to the RJ-11 connector on the end of the handset, and the other end to the RJ-
11 connector on the underside of the terminal.
Note:
You can tuck the cord into the indent at the side of the terminal.
3.
Connect the Ethernet cable (provided with the BluStar) into the network LAN port marked with
network system administrator for help with this connection.
4.
Plug the other end of the Ethernet cable directly into the jack on the wall.
5
. Contact your
41-001389-00 Rev 02 – 04.2012
Advertisement
Table of Contents
