Oam Ping Test - ZyXEL Communications SBG3500-N000 User Manual

Figure 192 Maintenance > Diagnostic > 802.1ag
The following table describes the fields in this screen.
Table 146 Maintenance > Diagnostic > 802.1ag
LABEL
802.1ag Connectivity Fault Management
Maintenance
Domain (MD) Level
Destination MAC
Address
802.1Q VLAN ID
VDSL Traffic Type
Loopback Message
(LBM)
Linktrace Message
(LTM)
Set MD Level
Send Loopback
Send Linktrace

42.5 OAM Ping Test

Click Maintenance > Diagnostic > OAM Ping Test to open the screen shown next. Use this
screen to perform an OAM (Operation, Administration and Maintenance) F4 or F5 loopback test on a
Chapter 42 Diagnostic
DESCRIPTION
Select a level (0-7) under which you want to create an MA.
Enter the target device's MAC address to which the SBG3500-N Series performs a CFM
loopback test.
Type a VLAN ID (0-4095) for this MA.
This shows whether the VDSL traffic is activated.
This shows how many Loop Back Messages (LBMs) are sent and if there is any inorder
or outorder Loop Back Response (LBR) received from a remote MEP.
This shows the destination MAC address in the Link Trace Response (LTR).
Click this button to configure the MD (Maintenance Domain) level.
Click this button to have the selected MEP send the LBM (Loop Back Message) to a
specified remote end point.
Click this button to have the selected MEP send the LTMs (Link Trace Messages) to a
specified remote end point.
SBG3500-N Series User's Guide
349