Add/Edit Qos Class - ZyXEL Communications SBG3500-N000 User Manual

destination port number or incoming interface. For example, you can configure a classifier to select
traffic from the same protocol port (such as Telnet) to form a flow.
You can give different priorities to traffic that the SBG3500-N Series forwards out through the WAN
interface. Give high priority to voice and video to make them run more smoothly. Similarly, give low
priority to many large file downloads so that they do not reduce the quality of other applications.
Click Network Setting > QoS > Class Setup to open the following screen.
Figure 78 Network Setting > QoS > Class Setup
The following table describes the labels in this screen.
Table 46 Network Setting > QoS > Class Setup
LABEL
Add new Classifier
#
Status
Class Name
Classification
Criteria
DSCP Mark
802.1P Mark
VLAN ID Tag
To Queue
Modify

10.5.1 Add/Edit QoS Class

Click Add new Classifier in the Class Setup screen or the Edit icon next to a classifier to open
the following screen.
Chapter 10 Quality of Service (QoS)
DESCRIPTION
Click this to create a new classifier.
This is the index number of the entry.
This field displays whether the classifier is active or not. A yellow bulb signifies that this
classifier is active. A gray bulb signifies that this classifier is not active.
This is the name of the classifier.
This shows criteria specified in this classifier, for example the interface from which
traffic of this class should come and the source MAC address of traffic that matches this
classifier.
This is the DSCP number added to traffic of this classifier.
This is the IEEE 802.1p priority level assigned to traffic of this classifier.
This is the VLAN ID number assigned to traffic of this classifier.
This is the name of the queue in which traffic of this classifier is put.
Click the Edit icon to edit the classifier.
Click the Delete icon to delete an existing classifier. Note that subsequent rules move
up by one when you take this action.
SBG3500-N Series User's Guide
191