TDK-Lambda Genesys GEN6-100 User Manual page 29

Programmable dc power supplies 750w/1500w in 1u built in rs-232 & rs-485 interface advanced parallel operation
Table of Contents

Advertisement

The 80V to 600V models have a four terminal wire clamp output connector:
Phoenix Contact P/N: FRONT4-H-7.62/4.
The two left terminals are the positive outputs and the other two right terminals are the negative
outputs. Max. 30A per terminal.
The connector requirements are as follows:
1. Wires: AWG18 to AWG10.
2. Tightening torque: 4.4-5.3Lb-inch. (0.5-0.6Nm).
Follow the below instructions for connection of the load wires to the power supply:
1. Strip approx.10mm at the end of each of the load wires.
2. Loosen the connector terminal screws.
3. Loosen screw "B" from enclosure bottom cover to release the shutter.
4. Insert stripped wires into enclosure bottom cover opening and then to the terminals,
tighten the terminals screws securely (see fig.3-8)
5. Loosen the two chassis screws marked "A" halfway.
6. Assemble the enclosure top cover to the chassis and tighten screws "A" (tightening torque:
4.8 - 5.3 Lb-inch).
Positive output (+)
Enclosure bottom cover
7. Assemble the enclosure bottom cover to it's place, as shown in Fig.3-9,using screw "C",
(tightening torque 4.8-5.3 Lb-inch).
8. Slide down the shutter to secure load wires in place, and tighten screw "B".
Enclosure top cover
A
A
Fig.3-8: Load wires connection to the output connector
C
Fig.3-9: Enclosure assembly
22
22
Negative (-)
Output/Return
Shutter
B
Load wires
B

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Genesys GEN6-100 and is the answer not in the manual?

Table of Contents

Save PDF