• If you must set addresses manually, turn off DHCP and enter the projector's IP Address, Subnet
Mask, and Gateway Address as needed. When manually entering IP Settings, you cannot use
restricted IP addresses.
Note: To highlight the numbers you want from the displayed keyboard, press the arrow buttons on
the remote control. To select a highlighted number, press Enter.
10. To prevent display of the IP address on the standby screen, turn off IP Address Display.
11. When you finish selecting settings, select Complete and follow the on-screen instructions to save
your settings and exit the menus.
Restricted IP Addresses
Parent topic:
Restricted IP Addresses
When manually entering IP Settings, you cannot use these ranges of IP addresses:
Setting
IP Address
Subnet Mask
Gateway Address
Parent topic:
Setting Up Projector Network E-Mail Alerts
You can set up the projector to send you an e-mail alert over the network if there is a problem with the
projector.
1. Press the Menu button.
Wired Network Monitoring and Control
Selecting Wired Network Settings
Restricted IP addresses
0.0.0.0
127.x.x.x
192.0.2.x
224.0.0.0 to 255.255.255.255
0.0.0.0
255.255.255.255
0.0.0.0
197.x.x.x
224.0.0.0 to 255.255.255.255
42