Epson PowerLite Pro Cinema LS10000 Quick Setup Manual

PowerLite Pro Cinema LS10000
®

Quick Setup

Before using the projector, make sure you read the safety instructions in the
online User's Guide (see the "Where to get help" section).

Choose a location

Keep the projector level and place it at a
height so its lens is even with the top or
bottom of the screen and is centered
horizontally. If this isn't possible, use the
lens shift feature or the keystone correction
button on the projector to reposition the
image (see "Adjust the image").
To view 3D images correctly, RF 3D glasses
must be worn within 32 feet (10 m) of the
projector. Use the image to determine the
viewing distance for 3D projection (the
shading represents the 3D viewing area):
See the online User's Guide for more information on where to place your
projector.
Connect the projector
Choose from the following connections. For additional connection types, see
the online User's Guide.

Video device

1
Loosen the two screws at the bottom of the cable cover, then pull the
cover forward.
2
Lift the cable cover out of the grooves at the top.
3
Connect up to 4 video devices and use the Source buttons on the remote
control or the button on the projector to switch between them.
HDMI cable
Component video cable
RCA video cable
Turn on your equipment
1
Turn on your video source.
2
Plug in the projector.
3
Press the power button on the projector or the On button on the
remote control. The shutter opens and the power light flashes blue,
then stays on.
Note: To shut down the projector, press the
projector or the Standby button on the remote control.
4
The default language of the menu system is English. To select another
language, press the Menu button on the projector or remote control.
Select Settings and press Enter. Select Language and press Enter. Select
your language and press Enter. Press the Menu button to exit the menu
system.

Using the remote control

Make sure the batteries are installed as shown (two AA batteries).
Turn projector on
Choose which source
to display
Control connected
sources with
HDMI Link
Adjust zoom, focus
and lens shift
Access projector
menus
Change the
3D format
For more information on using the remote control, see the online
User's Guide.
power button on the
Turn projector off
Turn off projector
display
Switch between
2D and 3D
Navigate projector
menus
Display test pattern