Installing The Log Set - Montigo HW38DF Operation Manual

HW-Series Gas Fireplace

Installing the Log Set

Installing the Logs:
Log 'D'
The HW38-DF is supplied with five ceramic fibre logs. Unpack the logs
and handle them very carefully.
Back Left Log
Mounting Tray
Bottom Left Log
Mounting Tray
Figure 29a. Log mounting base, placement locations.
All ceramic fibre Logs have been designed to enable quick and easy
placement. Please follow the instruction below.
Bottom Left Log
Figure 29b. Bottom left & right log placements.
1. Place the bottom left and right logs as shown above in figure
29b.
Back Left Log
Figure 29c. Back Left log placement.
2. Place the back left log on top of the bottom left log, while resting
the right side of the log on the mounting tray. As shown in figure
29c.
Page 16
Installation
Bottom Right Log
Mounting Tray
Bottom Right Log
Log Base
Base Log
Notch
3. Place the top right log as shown below in figure 29d. Align the
tab on the underside of the log, far right end, with the provided
notch in the bottom right log, Figure 29c.
Figure 29d. Top right log placement.
4. Rest the top log in the provided notch on top of the Top right log,
figure 29d.
5. Place the left end of the log as shown below in figure 29e.
Top Left Log
Top Left Log
Figure 29e. Completed log placement.
Cautions:
If logs are not placed properly, excessive sooting
■
will result.
The surface of the logs will crack due to the heat from
■
the flames. This is a normal occurrence.
WARNING!
Do not attempt to clean glass when hot.
Do not clean glass with abrasive materials as any glass etching
may cause premature glass failure.
Do not operate this fireplace without the glass door, or with a
broken glass door.
Notch
Part No. XG0190 - 071409