Installing The Log Set; Section 9: Installing The Accessories - Montigo HW38DF Installation & Maintenance Manual

H*38DF Gas Fireplace

Section 9: Installing the Accessories

Installing the Log set:

The H38DF* is supplied with a six ceramic fibre log logset. Unpack the
logs and handle them very carefully.
Step 1. Remove the glass door as described in the previous Instructions.
Rear / Bottom Log
Log A
Pilot Assembly
Notch in Log
Fireplace Base
Figure 27g. Bottom Rear Log, (Log A).
Step 2. Place the bottom Rear log (Log A) as shown in figure 27a.
Log C
Fireplace Base
Figure 27h. Left front Log, (Log C) and Right front Log, (Log B).
Step 3. Place the bottom Right log (Log B) and bottom Left Log, (Log
C) as shown in figure 27b.
Log D
Fireplace Base
Figure 27i. Top Left Log, (Log D).
Step 5. Place Front Left log (Log D) as shown in figure 27c.
Page 26
Installation
Air Inlets
Log B
Air Inlets
Air Inlets
Air Inlets
Fireplace Base
Figure 27j. Top Right Log, (Log E)..
Step 6. Place Front Right log (Log E) as shown in figure 27e.
Log F
Fireplace Base
Figure 27k. Front Left Log, (Log F).
Step 7. Place Front Left log (Log F) as shown in figure 27f. Set notch
in lower end of Log F against stile on Log Grate.
Figure 27l. Completed Logset.
NOTICE
If logs are not placed properly, excessive sooting will result.
Log E
XG0147 - 150204