Table of Contents
Advertisement
Quick Links
HT-Series PV Gas Fireplace
Warning:
Improper installation, adjustment, alteration, service or maintenance can cause
injury or property damage. Refer to this manual. For assistance or additional
information consult a qualified installer, service agency or the gas supplier.
Safety Notice:
Glass doors on gas fireplaces are extremely hot while the fireplace is on and remain
hot even after the fireplace has been turned off. Safety screens are available and
can reduce the risks of severe burns.
For Your Safety:
Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
Canadian Heating Products Inc. Langley, BC V4W 4A
XG0530
Installation Operation & Maintenance Manual
Check local codes and read all instructions prior to installation.
®
C
US
f i r e f e a t u r e
www.montigo.com
What to do if you smell gas
•
•
•
•
Montigo Del Ray Corp. Ferndale, WA 98248
HT34-PV
Indoor
Warning:
Do not try to light any appliance.
Do not touch any electrical
switch; do not use any phone in
your building.
Immediately call your gas
supplier from a neighbor's
phone. Follow the gas supplier's
instructions.
If you cannot reach your gas
supplier, call the fire department.
•
Installer: Leave this manual
with the appliance.
•
Consumer: Leave this
manual for future reference.
041510
Advertisement
Table of Contents
Related Manuals for Montigo HT34-PV Series
Summary of Contents for Montigo HT34-PV Series
-
Page 1: Safety Notice
• Installer: Leave this manual with the appliance. ® • Consumer: Leave this manual for future reference. Canadian Heating Products Inc. Langley, BC V4W 4A Montigo Del Ray Corp. Ferndale, WA 98248 XG0530 041510... -
Page 2: Table Of Contents
As the owner of this new fireplace, you'll want to read and care- fully follow all the instructions contained in this Installation, Your new Montigo gas fireplace will give you years of durable, Operations and Maintenance manual. Pay special attention to all reliable use. -
Page 3: Introduction
About this Fireplace: homeowner. However, all installation and service work should be The HT34-PV Series is an fireplace that is designed to compliment your performed by a qualified or licensed installer, plumber, or gas fitter who home and decor. This fireplace can be converted to both a Top Vent or... -
Page 4: Installation
2" clearance must still be maintained around the vent pipes.) Clearances Note: PV venting Not exactly as shown. These clearances apply to all dimensions except the framed opening, where the clearance to combustibles is 0". The HT34-PV Series MEL Short clearances to combustible materials are: Header... -
Page 5: Installing The Gasline
Installation Installing The Gas Line Vent Installation The gas line must be installed before finishing the HT34-PV Series This section covers the installation of direct venting and terminations. Fireplace. Natural Gas requires a minimum inlet gas supply pressure Installation Requirements of 5.5"... -
Page 6: Installing The Standoffs
2. Fasten the termination to the studs using a minimum of 4 screws. Installing The Standoffs Installing Terminations with MOSR Frames To avoid elevated mantel temperatures, all HT34-PV Series gas MOSR fireplaces are required to have the supplied standoffs installed. -
Page 7: Converting Vent Runs
HT34-PV Series Power Vent Gas Fireplace Installation Converting to Top Vent/ Rear Vent HT34-PV Rear Vent HT34-PV Top Vent Use the following instructions to convert an HT34-PV for Top Vent use: Use the following instructions to convert an HT34-PV for Top Vent use: 1. -
Page 8: Power Vent Runs
HT34-PV Series Power Vent Gas Fireplace Installation Installing The Horizontal & Mantels & Surrounds NOTE: National Canadian Gas Association mantel test requirements Vertical Exterior Power Vent are for fire hazard prevention to combustible materials. A Power Vent is required for the HT34-PV rear or Top vent gas fire- New technology, to meet consumer and government demands for the place. -
Page 9: Wiring
Wiring for the HT34-PV-I with Honeywell gas control and pilot. Wiring for the optional Fan Kit All HT34-PV Series fireplaces may be equipped with optional fan kits for circulating heat into the living space. Installations in Canada which employ the fans must be electrically grounded in accordance with CSA C22.1 Canadian Electrical Code... -
Page 10: Removing And Installing The Door
Ensure the tool is firmly Removing the door: in the lower end of the The HT34-PV Series door is removed in a few simple steps. Follow these slot, (as shown), Then pull Steps below to remove the Horizontal access panel, unlatch the door toward you (Caution: hold buckles and, remove the door. - Page 11 HT34-PV Series Power Vent Gas Fireplace Installation WARNING! Do not attempt to clean glass when hot. L42DF-ST Do not clean glass with abrasive materials as any glass etching may cause premature glass failure. Do not operate this fireplace without the glass door, or with a broken glass door.
- Page 12 HT34-PV Series Power Vent Gas Fireplace Operation - Model HT34-PV-I HT34-PV-I with Honeywell Electronic Ignition For Your Safety - READ BEFORE LIGHTING: WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
-
Page 13: Lighting Instructions
HT34-PV Series Power Vent Gas Fireplace Operation - Model HT34-PV-F HT34-PV-F with Proflame SIT Electronic Ignition with American Flame Electronic Ignition For Your Safety - READ BEFORE LIGHTING: WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. -
Page 14: Operation
HT34-PV Series Power Vent Gas Fireplace Operation Maintenance Lighting Instructions General Have the fireplace and installation inspected yearly. The inspection See pages 12 to 14. ■ must include, but is not limited to, the following: • A visual check of the entire vent system and termination. -
Page 15: Troubleshooting
HT34-PV Series Power Vent Gas Fireplace Maintenance Troubleshooting Troubleshooting HT34-PV-I HT34-PV-F Follow this information to reset the SIT System: HONEYWELL SV9500 /9600 1. Locate the lead to the battery backup, (remove) Troublshooting Sequence (Refer to schematic, below) NOTE: Before Troubleshooting, Familiarize Yourself With The Startup And Checkout Procedure. -
Page 16: Warranty
The duration of any implied warranty with respect to this Montigo Gas Appliance is limited to the duration of the foregoing warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above may not apply to you. -
Page 17: Termination Locations
HT34-PV Series Power Vent Gas Fireplace Appendix A - Termination Locations A = clearance to the termination frame above grade, veranda, porch, deck, clearance above paved sidewalk or a paved driveway located on public † or balcony [16 inches (41 cm) minimum] property [*7 feet (2.1 m) minimum]... -
Page 18: B State Of Massachusetts / Amendment
HT34-PV Series Power Vent Gas Fireplace Appendix B - State of Massachusetts Amendment (Gas Fireplace / Equipment sold in the State of Massachusetts) 5.08: Modifications to NFPA-54, Chapter 10 (1) Revise NFPA-54 section 10.5.4.2 by adding a second exception as follows:... -
Page 19: Notes
HT34-PV Series Power Vent Gas Fireplace Notes Page 19 Part No. XG0530 - 041510... - Page 20 XG0530 - 041510 Montigo Del Ray Corp. Canadian Heating Products Inc. Ferndale, WA 98248 Langley, BC V4W 4A1...