Goodman GSH Series Service Instructions Manual page 88

HEAT PUMP SPECIFICATIONS
Cooling Capacity, BTUH
Compressor
R.L. Amps
L.R. Amps
Loss of Charge Pressure Switch
Open / Close
Condenser Fan Motor
Horsepower
F.L. Am ps
Liquid Line, Inches O.D.
Suction Line, Inches O.D.
Refrigerant Charge
Design Subcooling Cooling (°F)
Power Supply
(1)
Minim um Circuit Ampacity
(2)
Maximum Overcurrent Device
Electrical Conduit Size
Power Supply (Inches )
Approximate Shipping Weight
(1)
Wire size should be determined in accordance with National Electrical Codes. Extensive wire runs will require larger wire sizes.
(2) Maximum Overcurrent Protection: Must use fuses or HACR-type Circuit Breakers of the same size as noted.
NOTES:
* Always check the S&R plate for electrical data on the unit being installed.
* Installer will need to supply 7/8" to 1 1/8" adapters for suction line connections.
* Unit is charged with refrigerant for 15' of 3/8" liquid line. System charge must be adjusted per Installation Instructions Final Charge Procedure.
* Installation of these units that require a TXV Kit to be installed on the indoor coil: PLEASE NOTE: THE SPECIFIED TXV IS DETERMINED BY THE OUTDOOR UNIT
NOT THE INDOOR COIL
18,000 23,000
6.2 9.2
35 43
7 PSIG/25 PSIG 7 PSIG/25 PSIG
1/6 1/6
1.1 1.1
3/8" 3/8"
3/4" 3/4"
127 122
9 + 3 9 + 3
208/230-60-1 208/230-60-1
8.9 12.6
15 20
1/2 or 3/4 1/2 or 3/4
177 177
28,000 35,000
10.8 12.2
60 73
7 PSIG/25 PSIG 7 PSIG/25 PSIG
1/6 1/4
1.1 1.5
3/8" 3/8"
3/4" 7/8"
130 188
9 + 3 9 + 3
208/230-60-1 208/230-60-1
14.6 17
20 25
1/2 or 3/4 1/2 or 3/4
185 207
GSH130[18-36]1B*
7