Protective Rubber Boots - Arctic Cat DVX 300 2010 Operator's Manual

2. Measure the thickness of each
brake pad.
3. If thickness of either brake pad is
less than 1.0 mm (0.039 in.), take
the ATV to an authorized Arctic
Cat ATV dealer to have brake pads
replaced.
4. Install the wheel and tighten using
a crisscross pattern to 40 ft-lb.
Brake Lever Lock
Check to make sure the brake lever lock
engages properly and that the brake
(when engaged) locks the wheels.
1. Pump the brake lever 2 or 3 times.
2. Engage the brake lever lock.
3. Attempt to push the ATV.
 NOTE: The brake lever lock must
lock the wheels. If it doesn't, take
the ATV to an authorized Arctic Cat
ATV dealer for service.
PROTECTIVE RUBBER
BOOTS
The protective
inspected periodically according to the
Maintenance Schedule.
Ball Joint Boots
(Upper and Lower/
Right and Left)
PR376B
1. Secure the ATV on a support stand
to elevate the front wheels.
2. Remove both front wheels.
3. Inspect the four ball joint boots for
cracks, tears, or perforations.
4. Check the ball joint for free-play
by grasping the steering knuckle
and turning it from side to side and
up and down.
5. If boot damage is present or ball
joint free-play seems excessive,
contact an authorized Arctic Cat
ATV dealer for service.
Tie Rod Boots
(Inner and Outer/Right
and Left)
KM161B
boots should be
KM117A
KM117B
65