Setting The Beep Level - Icom IC-F29SR Operating Instructions Manual

4
SETTINGS

Setting the beep level

You can adjust the beep level between 1 and 5, or 1
(linked) and 5 (linked).
When a linked option is selected, you can adjust the
beep level by rotating [VOL].
[VOL] to turn OFF the transceiver power.
Rotate
q
Set [ROTARY SELECTOR] to any channel other
w
than Channel 16.
While holding down
e
ON the power and enter the beep level adjustment
mode.
Push [Upper] to change the beep level as shown to
r
the right.
• A beep sounds every time you push [Upper]. Therefore,
you can determine the current level setting by the in-
creasing loudness of the beep that sounds.
• To determine if you have selected a linked level, set [VOL]
to minimum, then push [Upper] repeatedly, listening for
the loudest beep (level 5). Pushing [Upper] once after
the loudest beep will select 1 (Linked). Repeatedly push
[Upper] to select the desired linked level.
[VOL] to turn OFF the power to exit the beep
Rotate
t
level adjustment mode.
[Lower], rotate [VOL] to turn
[ROTARY SELECTOR]
[Upper]
[Lower]
6
[VOL]
Pushing
[Upper]
5
4
3
2
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)