Setting The Beep Level - Icom F2000D 01 Operating Manual

5
USER SETTINGS

Setting the Beep level

The Beep level is adjustable between 1 and 5, or
1 (linked) and 5 (linked). When a Linked option is
selected, the beep audio level is adjustable by rotating
[VOL].
NOTE:
You should turn ON the Beep function (p. 5-2)
before you start setting the Beep level.
1) Rotate [VOL] to turn OFF the transceiver.
2) Set [ROTARY SELECTOR] to any channel other
than Channel 16.
3) While holding down [Lower], rotate [VOL] to turn
ON the power and enter the Beep level adjustment
mode.
4) Push [Upper] to change the Beep level.
• R epeatedly pushing [Upper] first selects 1 (lowest) to
5 (highest), and then selects the lowest linked level, 1
(Linked) to the highest, 5 (Linked). Repeatedly pushing
[Upper] repeats the cycle. See the illustration on the
right.
• T he adjustable range is 1 to 5 or 1 (Linked) to 5
(Linked).
• A beep sounds every time you push [Upper]. Therefore,
you can determine the current level setting by the
increasing loudness of the beep that sounds.
• T o determine if you have selected a linked level, set
[VOL] to minimum, then push [Upper] repeatedly,
listening for the loudest beep (level 5). Pushing [Upper]
once after the loudest beep will select 1 (Linked).
Repeatedly push [Upper] to select the desired linked
level.
5) Rotate [VOL] to turn OFF the power to exit the
Beep level adjustment mode.
[ROTARY SELECTOR]
[Upper]
[Lower]
5-3
[VOL]
Pushing
[Upper]
5
4
3
2
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)