D Transmitting A Group Call - Icom IC-M506 Instruction Manual

7
DSC OPERATION
D Transmitting a Group call
The Group call function allows you to transmit a DSC signal
to only a specific group.
Enter "GROUP CALL" in the DSC CALLS menu.
q
➪
MENU DSC
(Push [MENU]) (Select icon)
Select the desired pre-programmed group address or
w
"Manual Input," using dial or [Y]/[Z], then push [ENT].
• The ID code for the Group call can be set first. (p. 20)
• When "Manual Input" is selected, set the 8 digit ID code for the
group you wish to call.
• Push [EXIT] to return to the normal operating mode.
• Push [BACK] to return to the previous screen.
33
➪ Group Call
(Rotate dial, then push [ENT].)
e Select a desired intership channel using dial or [Y](CH)/
[Z](CH), then push [ENT].
• Intership channels are already preset into the transceiver in the
recommended order.
About Manual Inputting:
Enter a desired group ID in the following way:
• Select a desired number using [Y]/[Z]/[Ω]/[≈].
• Push [ENT] or dial to set it.
• To move the cursor, rotate dial or select either arrow, "←" or "→,"
then push [ENT] or dial.
• The first digit is specified as '0' for a Group ID.
• The first two digits are '0' for any Coast station ID.