Preparation; Mmsi Code Programming - Icom IC-M506 Instruction Manual

MMSI code programming

■
The 9 digit MMSI (Maritime Mobile Service Identity: DSC self
ID) code can be programmed at power ON.
This initial code setting can be performed only once.
After being set, it can be changed by only your dealer
or distributor. If your MMSI code has already been pro-
grammed, this programming is not necessary.
Hold down [PWR](Dial) to turn ON the power.
q
• Three short beeps sound, and "NO DSC MMSI" is displayed.
Push [ENT] to start the MMSI code programming.
w
• Push [CLEAR] twice to cancel the programming, and go to the
normal operating screen. In this case, the transceiver cannot
make a DSC call. To program the MMSI code, turn OFF the
power, then turn it ON again.
Enter your MMSI code in the following manner:
e
• Select a desired number using [Y]/[Z]/[Ω]/[≈].
• Push [ENT] or dial to set it.
• To move the cursor, rotate dial or select either arrow, "←" or "→,"
then push [ENT] or dial.

PREPARATION

Repeat step e to enter all 9 digits.
r
After entering the 9 digit code, "FINISH" is automatically
t
selected, and then push [ENT] or dial to set it.
The "MMSI CONFIRMATION" screen is displayed.
y
Enter your MMSI code again for confirmation.
u
• Enter in the same manner as steps e through t.
When your MMSI code programming is successfully com-
i
pleted, the screen as shown below is briefly displayed.
• After that, the normal operating screen is displayed.
The programmed MMSI code can be checked in the MENU
screen. (p. 92)
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
8