Installing A Bale-Clasp Sfp Module - Cisco ASR 14000 Series Installation Manual

How to Install or Remove a Small Form-Factor Pluggable (SFP) Module
Because invisible laser radiation may be emitted from the aperture of the port when no cable is
Warning
connected, avoid exposure to laser radiation and do not stare into open apertures. Statement 70

Installing a Bale-Clasp SFP Module

This section describes how to install a bale-clasp SFP module. The module has a clasp used to install
and remove the module (see
Figure 4-37
Prerequisites
Before installing a module, remove any front cover plates.
Required Tools and Equipment
You need the following tools and part to perform this task:
•
•
Steps
To install a bale-clasp SFP module (into a PLIM), follow these steps:
Attach the ESD-preventive wrist strap to your wrist and connect its leash to an ESD connection socket
Step 1
on the front (PLIM) side or a bare metal surface on the chassis.
Close the bale clasp before inserting the module.
Step 2
Align the module with the port and slide it into the port (see
Step 3
Note
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
4-56
Figure
Bale-Clasp SFP Module
ESD-preventive wrist strap
Bale-clasp SFP module
Be careful to hold the module in such a way so as to not damage the bale clasp.
Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
4-37).
Figure 4-38).
OL-16973-01