Misfeed In Tray 1 - Sharp MX-M200D Operation Manual

Misfeed in C
1
Lower (1) in the illustration, open the
fusing unit paper guide, and remove
the misfed paper.
Be careful not to tear the misfed
paper during removal.
(1)
The fusing unit is hot. Do not touch
Warning
the fusing unit when removing
misfed paper. Doing so may cause a
burn or injury.
2
If the misfed paper cannot be removed
by the previous step, remove it from
the paper output area.
Be careful not to tear the misfed
paper during removal.

MISFEED IN TRAY 1

Make sure that there is no misfed paper in the tray before pulling it out. (Page 31)
Note
1
Pull out tray 1 and remove the misfed
paper.
Be careful not to tear the misfed
paper during removal.
2
Open and close the side cover.
The message "
path." will be cleared and
copying will be possible.
• When closing the side cover, hold the
Note
handle.
• If the message does not clear, check
again to make sure that no pieces of
paper remain.
3
Close the side cover.
Note
3
Gently push tray 1 into the machine.
Clear paper
TROUBLESHOOTING AND MAINTENANCE
The message "
path." will be cleared and
copying will be possible.
• When closing the side cover, hold the
handle.
• If the paper was torn, make sure that no
torn pieces remain in the machine.
• If the message does not clear, check
again to make sure that no pieces of
paper remain.
Push the tray in completely.
Clear paper
2
33