Two-Sided Copying Of One-Sided Originals - Sharp MX-M200D Operation Manual

TWO-SIDED COPYING OF ONE-SIDED ORIGINALS

• Paper sizes that can be used are 11" x 17", 8-1/2" x 14", 8-1/2" x 13", 8-1/2" x 11", 8-1/2" x 11"R, A3, B4, A4, A4R,
B5, B5R and A5.
• Automatic two-sided copying is not possible when the bypass tray is used.
Copying from the RSPF
1
Make sure that an original does not
remain on the document glass, and
then adjust the original guides to the
width of your originals and place the
originals face up in the document
feeder tray.
If you placed an odd number of
originals, the last copy will be
one-sided.
2
Press the [DUPLEX] key.
OUTPUT DUPLEX
ORIGINAL SIZE DUPLEX SCAN
DUPLEX SCAN
T ORIGINAL SIZE
The duplex mode selection
screen appears.
3
Select "1 to 2" with the [ ] or [ ] key,
or with the [DUPLEX] key.
PQ
UPLEX
LEX SCAN
LEX SCAN
ACC
COPY MODE
1 to 1
1 to 2
2 to 2
COPY MODE
1 to 1
1 to 2
2 to 2
BINDING CHANGE OFF
4
If you wish to have the orientation of
the image on the back of the copy
paper be opposite the orientation of
the image on the front, set "BINDING
CHANGE" to "ON" with the [ ] or [ ]
key.
If the copies are to be bound at the top, reversing the
orientations of the images on the front and back sides
of each copy will result in a uniform orientation when
the bound copies are viewed (note that this may
depend on the orientation of the originals).
5
Press the [OK] key.
You will return to the base
GHI
BACK
OK
screen.
PQRS
X
AN
6
Set the number of copies and press
the [START] key (
To stop copying in the middle of
WXYZ
a run, press the [C] key.
COPY FUNCTIONS
COPY MODE
1 to 1
1 to 2
2 to 2
BINDING CHANGE ON
).
57
4