Switching - Sharp MX-M200D Operation Manual

BEFORE USING THE PRODUCT
DISABLING (ENABLING) AUTO TRAY SWITCHING
When auto tray switching is enabled and paper runs out during copying or printing, the job will continue using paper
from a different tray if that tray has the same size of paper in the same orientation. (This function does not operate
when using the bypass tray or when a fax is being printed.) This function has been enabled at the factory. If you
prefer to disable the function, follow the steps below.
1
Press the [SPECIAL FUNCTION] key.
ON LINE
DATA
SPECIAL
FUNCTION
LINE
COPY EXPOSURE PAPE
DATA
SCAN COLOR MODE RESOLUT
The special function
screen will appear.
The above screen appears in copy mode.
2
Select "PAPER SIZE SET" with the [ ]
or [ ] key.
PQ
UPLEX
LEX SCAN
LEX SCAN
ACC
3
Press the [OK] key.
GHI
BACK
OK
PQRS
X
AN
The paper size setting
screen will appear.
4
Press the [ ] key repeatedly until
"AUTO TRAY SWITCHING" appears.
Move the cursor to the lowest tray and then press the
[ ] key again. The above screen will appear.
22
SPECIAL FUNCTION
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
DISPLAY CONTRAST
SPECIAL FUNCTION
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
DISPLAY CONTRAST
PAPER SIZE SET
8 x11R 1 11x17
2
11x17 8 x14 1
2
8 x13 1
2
8 x11 1
2
PAPER SIZE SET
AUTO TRAY

SWITCHING

5
Press the [OK] key.
OK
When a checkmark does not appear in the checkbox,
the auto tray switching function will not operate.
6
Press the [ ] key.
You will return to the
paper size setting screen.
To re-enable auto tray switching, press the [OK] key in
the screen of step 5 so that a checkmark appears.
PAPER SIZE SET
AUTO TRAY
SWITCHING
PAPER SIZE SET
8 x11R 11x17
1
2
11x17 8 x14 1
2
8 x13 1
2
8 x11 1
2