One-Sided Copies Of Two-Sided Originals - Sharp MX-M200D Operation Manual

COPY FUNCTIONS

ONE-SIDED COPIES OF TWO-SIDED ORIGINALS

• Paper sizes that can be used are 11" x 17", 8-1/2" x 14", 8-1/2" x 13", 8-1/2" x 11", 8-1/2" x 11"R, A3, B4, A4, A4R,
B5, B5R and A5.
• Automatic two-sided copying is not possible when the bypass tray is used.
• This copy function cannot be used in combination with dual page copy.
1
Make sure that an original does not
remain on the document glass, and
then adjust the original guides to the
width of your originals and place the
originals face up in the document
feeder tray.
2
Press the [DUPLEX] key.
OUTPUT DUPLEX
ORIGINAL SIZE DUPLEX SCAN
T ORIGINAL SIZE DUPLEX SCAN
The duplex mode selection
screen appears.
3
Select "2 to 1" with the [ ] or [ ] key,
or with the [DUPLEX] key.
PQ
UPLEX
LEX SCAN
LEX SCAN
ACC
60
COPY MODE
1 to 1
1 to 2
2 to 2
COPY MODE
1 to 2
2 to 2
2 to 1
BINDING CHANGE OFF
4
If you wish to have the orientation of
the back image be opposite the
orientation of the front image, set
"BINDING CHANGE" to "ON" with the
[ ] or [ ] key.
If the copies are to be bound at the top, reversing the
orientations of the front and back images will result in a
uniform orientation when the bound copies are viewed (note
that this may depend on the orientation of the originals).
5
Press the [OK] key.
You will return to the base
GHI
BACK
OK
screen.
PQRS
X
AN
6
Set the number of copies and press
the [START] key (
To stop copying in the middle of
WXYZ
a run, press the [C] key.
COPY MODE
1 to 2
2 to 2
2 to 1
BINDING CHANGE ON
).