SAB Explorer PVR SC User Manual page 17

Menu Guide :
Installation
◈ Service Searching
Edit
* When selecting "MOTOR" Yellow color key(in DiSEqC menu)
• DiSEqC 1.2 Motor : You can move the motor to the left or right by pressing the
◀▶ keys continuously, but when you stop pressing the ◀▶ keys, the motor will
be stopped.
• Save : When you press the "OK" key, current position of the DiSEqC motor will
be saved.
• Go to Reference : Move to the position "O".
• Calculation : The difference between the current position and the new position of
the current satellite is applied to all the other satellite also.
• Limit : You can set the maximum move extent. You can control "Enable" or
"Disable" mode. When you select "Enable", "East limit" and "West Limit" will be
activated.
Press the "OK" key, then current position will be restored as each limit.
• Reset : After select the "Reset" and press the "OK" key, the original value of
motor will be restored.
* When selecting "USALS" Yellow color key(in DiSEqC menu)
Input the value of latitude and
longitude in which the dish-installer is
placed.
As the satellite that you want to target
was selected in the last menu, it is
possible to press "OK" key in "Rotate".
Then the degree of an angle for rotate
will be calculated automatically and
the DiSEqC Motor will adjust to rotate
the dish to the previously selected
target satellite.
First of all, when you set this procedure, notice the following point, that is, the zero
degree of DiSEqC Motor must be headed for the due North at initial setup state.
17