Fitting The Furniture Doors - Miele KFN 37432 iD Operating And Installation Instructions

Building in the appliance

Fitting the furniture doors

The furniture door must be at least
16 mm thick and not exceed 19 mm
thick.
The following gap dimensions must be
maintained:
– The gap between the furniture door
and a unit door above must be at
least 3 mm.
– The vertical gap between furniture
doors should also be about 3 mm.
The exact dimension will vary
depending on the radius of the
furniture door edges.
If fitted in a run of units make sure that
the top edge of the furniture door is at
the same height as neighbouring unit
doors.
The furniture door must be fitted
correctly and not under tension.
88
Fitting a door front which is heavier
than the maximum permitted could
damage the hinges. This can cause
subsequent functional problems.
Before fitting furniture doors, ensure
that the weight of the door does not
exceed the maximum permitted:
Appliance
KFN 37432 iD
KFNS 37432 iD
When fitting large or divided furniture
doors an extra fitting kit or set of
fixing brackets should be used.
These are available to order from
Miele.
max. max.
weight weight
of of lower
upper door in
door in kg
kg
20 12
20 12