Miele KFN 37432 iD Operating And Installation Instructions page 59

Display warnings
Problem
The alarm symbol ;
flashes in the display
together with the
sensor for one of the
sections.
The alarm sounds
and the power failure
symbol t appears in
the display.
The temperature
display will show the
warmest temperature
recorded in the
freezer during an
interruption to the
power supply or a
power cut.
Possible cause
The temperature in the zone
concerned has risen higher
or fallen lower than the
temperature set. This could
be due to:
– the door being opened
too frequently.
– a large amount of fresh
food being put in at once
for freezing without
switching on the Super
freeze function.
– a lengthy interruption of
the power supply.
The temperature in the
appliance in the previous
days or hours has risen too
high because of a power
cut or interruption to the
power supply.
The appliance will go back
to the last temperature
setting when the power is
back on.
Problem solving guide
Remedy
^ Rectify the cause of the
alarm. The alarm symbol
; goes out and the
sensor for the section
concerned lights up
constantly. The audible
alarm stops.
Depending on the
temperature in the freezer
section, you should check
the condition of the food. If
food has defrosted or
started to defrost, check
that it is still safe to use and
if so, use it as quickly as
possible. Defrosted food
may only be re-frozen after
it has been cooked.
^ Touch the alarm off
sensor.
The warmest temperature
display will go out. The
display will then revert to
showing the current
temperature in the freezer.
^ Depending on the
temperature displayed, you
should check the condition
of food in the freezer. If it
has defrosted or started to
defrost, check that it is still
safe to use and, if so, use it
as soon as possible.
Defrosted food may only
be re-frozen after it has
been cooked.
59