Table of Contents
Advertisement
Chapter 2 Preparations
1.14.1 Installation
Install a backup device by using the following procedure.
1.
Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Remove the side cover and front bezel while referring to Chapter 2 (1.4 Removing the Side Cover and
1.5 Removing the Front Bezel).
3.
Remove the blank cover. Push the tab on the tray
and pull out the device tray from the 3.5-inch device
bay.
4.
Mount the backup device on the device tray.
Secure the backup device on the left and right sides
by using the two screws that come with the server.
5.
Insert the backup device into chassis.
Do not push the backup device in completely as
the cable has to be connected to the device.
6.
Connect the interface cable and power cable to the installed 3.5-inch backup device.
For more information, refer to Chapter 2 (1.15 Connecting cables).
7.
Push the device all the way until it locks with a clicking sound.
8.
Assemble the server.
9.
Install device drivers for installed backup device as needed.
For more information, refer to the manual provided with the backup device.
1.14.2 Removal
You can remove the backup device by reversing the installation procedure. If the devices are to remain
removed, attach the stored dummy cover.
Important
Use screw set 502 supplied with this server to attach the backup device to the tray.
Express5800/T110f-S User's Guide
1. Installing Internal Optional Devices
1
2
91
Advertisement
Table of Contents
