Table of Contents
Advertisement
Chapter 2 Preparations
1.13
Optical Disk Drive
Procedures for replacing the standard optical disk drive with the optional internal DVD SuperMULTI drive are
described below.
1.13.1 Replacing drives
Follow the procedure below to replace your drive with the optional internal DVD SuperMULTI drive.
1.
Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Remove the side cover and front bezel while referring to Chapter 2 (1.4 Removing the Side Cover and
1.5 Removing the Front Bezel).
3.
If a device or an extra 2.5-inch HDD cage is installed in the 3.5-inch device bay (1), remove it so that
you can access the cable connected to the optical disk drive.
4.
Disconnect the SATA cable and DC power cable
from the optical disk drive.
5.
Push the stopper on the right side (as viewed from
the front) and remove the optical disk drive.
6.
Remove the bracket from the optical disk drive.
88
Important
Do not install a drive other than those specified by NEC.
Express5800/T110f-S User's Guide
1. Installing Internal Optional Devices
Stopper
Advertisement
Table of Contents
