Table of Contents
Advertisement
Chapter 2 Preparations
1.12.6 Installing the hard disk drive
Install a 2.5-inch Hard Disk Drive in the server by using the following procedure.
1.
Unlock and open the door of the 2.5-inch
drive bay.
2.
Install the hard disk drives in the HDD cage.
Fully open the lever on the hard disk drive
tray, and then insert the hard disk drive until
it comes into contact with back of the HDD
cage (1).
When finished, close the lever to lock the
hard disk drive (2). (You will hear a click.)
3.
Close the door and lock it by using the key.
Important
Use only the hard disk drives recommended by NEC.
Ask your sales agent or service representative for details.
Note
Make sure that the orientation of the hard disk drive (tray) before insertion (see the
figure) is correct. In addition, make sure that the hook of the lever engages with
the frame of the HDD cage when the lever is closed.
Important
If you remove two or more hard disk drives while the server is on, the logical
drive will be damaged. Remove or replace the hard disk drives one by one.
Express5800/T110f-S User's Guide
1. Installing Internal Optional Devices
1
2
87
Advertisement
Table of Contents
