Hook Up The Elevator And Rudder - GREAT PLANES Reactor ARF .61-.91 SPORT BIPLANE Instruction Manual

❏
8. Use a small metal ruler or straightedge to work
30-minute epoxy down into the slot in the fuselage for the tail
gear bearing. Apply epoxy to the bearing, then fi t it into the
slot. Wipe away excess epoxy.
❏
9. Apply epoxy in the hole in the rudder for the tail gear
wire and apply epoxy to the arm. Make sure the rudder
hinges are in place, then join the rudder to the fuselage with
the hinges. Wipe away any excess epoxy.
❏
10. Remove the pins from the hinges and permanently
join the rudder to the fuselage by gluing in the hinges with
thin CA.

Hook Up the Elevator and Rudder

❏
1. Connect your servo extensions to the rudder and elevator
servos. Secure the connectors with 1-1/2" [38mm] pieces of
heat shrink tubing cut from the 3" [76mm] tubing supplied.
Use a heat gun or a hobby torch to shrink the tubing.
Refer to these photos while hooking up the elevator and
rudder servos.
❏
2. Mount the elevator and rudder servos in the fuselage
using the screws that came with them.
12