Brickcom WCB-100A User Manual page 14

WPS
WPS
Firmware Steady On
Upgrade
Privacy Steady On
Privacy Unlighted
Hardware Reset
The reset button is used to reset the system or restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the problems remain after
reset, please restore the factory settings and install it again.
Reboot - Please press and release the indented reset button within 1 second with paper clip
or thin object. Wait for the network camera to reboot.
Restore - Please press and hold the reset button until the status of LED turns off. It takes
about 10 seconds. Please note that all settings will be restored to factory default. Upon
successful restore, the status of LED will be blue again during normal operation.
Micro-SD Card Capacity
The network camera is compliant with Micro-SD (Maximum 32GB) cards.
Session overlap detected
WPS Success
Firmware Upgrade
Success
Privacy mask active
Privacy mask inactive
Reset Button
- 5 -
WCB-100A
Fourth (Blue)
WCB-100A
Fourth (Blue)
CB-100A
Fourth (Blue)
Bottom(Red)
Bottom(Red)