Selecting The Input Data Stream; Setting The Lnb Oscillator Frequency - Triax CCS 1000 S Assembly Instructions Manual

Bx 4
Tuner A /
Tuner A
Tuner B /
ASI
Bx 4 Bx 4
Tuner A / Tuner A /
Tuner A Tuner A
Tuner B / Tuner B /
ASI ASI

Selecting the input data stream

In this menu you select the signal source for the selection of
the services. The data streams to be processed are provided
by "Tuner A", "Tuner B" and the ASI interface "ASI".
INPUT
OK =>
D
• Press the
input data stream ("Tuner A", "Tuner B", "ASI").
—> "OK" indicates that an input signal is available. If
there is no input signal available "– –" is displayed
instead of "OK".
• Press the button.
▶
—> The "Setting the LNB oscillator frequency" – "LNB"
menu is activated.

Setting the LNB oscillator frequency

Set the oscillator frequency of the LNB used in this menu.
INPUT INPUT
OK OK => =>
D D D
• Using the
or "9750" can be selected directly.
• To set other oscillator frequencies use the
place the cursor under the digit of the oscillator frequency
displayed to be set.
• Press to enter the respective digit of the oscillator
frequency of the LNB used.
• Repeat the procedure by the quantity of the digits to be
set.
- 19 - - 19 -
Bx 4A Bx 4A LNB LNB
10600 MHz 10600 MHz
buttons to select the signal source of the
Bx 4A LNB
10600 MHz
button the oscillator frequencies "10600"
/ /
10600 / 9750 10600 / 9750
/
10600 / 9750
/
buttons to
◀ ▶