Page 2
QUAD and QUATRO Optical Virtual Converter/Receiver Installation Guide Introduction The purpose of this guide is to enable the successful installation of the Triax TVC 05 QUAD and TVQ 05 QUATRO products. This guide assumes that; The converter is connected to a suitable Triax Passive Optical Network (PON), providing a minimum optical signal levels of -12dBm at the connection point of the converter.
Page 3
QUAD and QUATRO Optical Virtual Converter/Receiver Installation Guide Fig.3 If using a splice, coil the fibre so that the splice tube aligns to the centre of the groove on the side of the base plate (Fig.4) tape down the coiled fibre on to the converter. Push the splice tube into the slot on the side of the base then coil the fibre around the base ensu- ring it is inserted in the slot, Covering the splice tube with at least one layer of protected fibre as shown in (Fig.5)
Page 7
SAT-Signal auch die terrestrische Signale (FM+DVB-T, sofern eingespeist). An die Ausgänge kö- nnen direkt 3-Loch SAT-Antennensteckdosen Triax FS 302 F mit selektiven SAT / TV / FM Auslässen ange- schlossen werden. Die QUATRO-Version TVQ 05 gibt jede der 4 SAT-ZF-Ebenen separat aus und besitzt einen zusätzliche Ausgang für die terrestrischen Signale.
G.657.A Anmerkung: Sowohl TVC 05 als auch TVQ 05 können über eine Set Top Box oder einen Multischalter oder über ein A.07.13 externes Netzteil (Triax Art. Nr 307657) mit Strom versorgt werden. Deutsch TVC 05, 307627 / TVQ 05, 307629...
Page 9
Guide de mise en service Convertisseurs Optiques TVC 05 / TVQ 05...
Page 10
Pour que l’installation du convertisseur soit optimale il est bien sur entendu que : Le convertisseur est raccordé à un réseau optique Triax dit PON (Passive Optical Network) et qui délivre un signal optique minimum à l’entrée du convertisseur de -12dBm.
Page 11
Guide de mise en service des convertisseurs optique QUAD et QUATRO Si vous utilisez une jarretière optique Triax pré-connectorisées renforcée (3mm), vous pouvez la faire passer dans la rainure du socle du convertisseur et enrouler jusqu’à 1,2m de fibre Triax de 3mm avant l’entrée optique du convertisseur comme montré ci-dessous.
Spécifications techniques TVC 05 QUAD 307627 EAN 5702663076273 Nom des produits / Références / EAN TVQ 05 QUATRO 307629 EAN 5702663076297 Satellite (Electrique) Paramètres Minimum Maximum Unité Bande de fréquences RF 2150 Impédance de sortie Ω Adaptation Variation du gain dans la bande Niveau de sortie nominal (TVC 05 QUAD) 70 *) dBµV...
Page 15
QUAD og QUATRO Optisk modtager — installationsvejledning Fig.3 Hvis der benyttes splicning skal fiberen vikles op således at splidsesømmet sidder i ril- len i midten af basispladens side (Fig.4). Tape den opviklede fiber fast ovenpå enheden. Tryk splidsesømmet fast ind i rillen på siden, og vikl det armerede grå kabel rundt om basispladens kant således at den sidder godt i rillen og udgør mindst én runde som be- skyttelse af det tynde fiber nederst, som vist i (Fig.5) Fig.4...