Allocating The Ip Addresses - Triax CCS 1000 S Assembly Instructions Manual

Bx 4
IP-OUT 1
...
Das Erste
IP-OUT 16
• Press the
—> The "Selecting the input data stream" – "INPUT" menu
is activated when the input signal source "Tuner A"
without a CA module installed and "Tuner B" are pro-
grammed (page 19).
—> Programming the input signal source "Tuner A" with
a CA module installed the "Setting the operating volt-
age for the CA module" – "CA Supply" menu is
activated (page 31).
• Use the
("Tuner B" / "ASI") and program them.
• Press the
—> The "Allocating the IP addresses" – "IP-OUT 1" menu
is activated.

Allocating the IP addresses

In this menu up to 16 services that are contained in the data
streams of the input source signals ("Tuner A", "Tuner B",
"ASI") can be accessed. The services detected receive an IP
address automatically.
In the following sub-menus you can set specific parameters
for each service.
IP-OUT 1
=>
• Press the
("IP-OUT 1" ... "IP-OUT 16").
—> In the second line of the display the service is indi-
cated allocated to the IP output (e.g. "Das Erste").
• Press the button.
▶
—> The "Switching the IP address off or on, selecting the
transmission protocol, setting the port number" –
"MODE / PORT" menu is activated.
button.
buttons to select further input signal sources
button.
IP 1 IP 1 MODE / PORT MODE / PORT
on on UDP UDP 1234 1234
buttons to select the IP outputs to be set
- 23 - - 23 -
/ /
on / off on / off
UDP / RTP, UDP / RTP,
0 ... 65535 0 ... 65535
copy copy