GREAT PLANES EP FALCON ARF Instruction Manual page 10

❏
4. If building the indoor wing, simply stick the plastic rubber
band protectors to the top of the wing at the leading and
trailing edges where shown.
❏
5. Cut the C.G. Marking Template from the back of the
manual and place it on the bottom of the wing, aligning the
front of the template with the leading edge. Use a fi ne-point
felt-tip pen to mark the ends of the C.G. lines on the template
onto the wing.
❏
6. Use a straightedge to draw lines connecting the dots
depicting the recommended balance range.
❏
7. Finally, apply narrow strips of tape over the lines so you
will be able to feel them with your fi ngers when balancing the
model later.
❏
8. Use a dab of RTV silicone or white glue to glue the pilot
into position directly on top of the wing or to the doubler (if
building the outdoor wing) 2-1/8" [54mm] from the leading edge.
10