10 - GAS SECTION
This appliance is supplied for use on
NATURAL GAS only and cannot be
used on any other gas without modifica-
This appliance is manufactured for
conversion to LPG if required.
If the injectors are not supplied they can
be obtained from the After-Sales
The cooker must be installed by a quali-
fied person in accordance with the Gas
(Amendment) Regulation 1990 and the
relevant building/l.E.E. Regulations.
The following British Standards should
be used as reference when installing
BS6172 1990, BS5440 part 2 1989 and
Failure to install the appliance correctly
could invalidate any manufacturers war-
ranty and lead to prosecution under the
above quoted regulation.
In the UK C.O.R.G.I registered installers
are authorised to undertake the installa-
tion and service work in compliance with
the above regulations.
The installation of the cooker to Natural
Gas or LP Gas must be carried out by a
qualified gas engineer. Installers shall
take due account of the provisions of the
relevant British Standards Code of
Practice, the Gas Safety Regulations
and the Building Standards (Scotland)
(Consolidation) Regulations issued by
the Scottish Development Department.
INSTALLATION TO NATURAL GAS
Installation to Natural Gas must conform
to the Code of Practice, etc. The supply
pressure for Natural Gas is 20 mbar.
INSTALLATION TO LP GAS
This appliance must only be connected
to LPG after an LPG conversion kit has
been fitted, (see pages from 28 to 30).
When operating on Butane gas a supply
pressure of 28-30 mbar is required.
When using Propane gas a supply pres-
sure of 37 mbar is required.
The installation must conform to the rel-
evant British Standards.
Warning: Only a qualified gas engineer,
also with technical knowledge of elec-
tricity should install the cooker. He
should observe the Regulations and
Codes of Practice governing such instal-
lation of gas cookers.
Note: It is recommended that the gas
connection to the cooker is installed with
a flexible connecting tube made to BS