11 - ELECTRICAL SECTION
IMPORTANT: The cooker must
be installed in accordance with
the manufacturer's instructions.
Incorrect installation, for which
the manufacturer accepts no
responsibility, may cause injury
to persons or animals etc.
– Connection to the mains must be car-
ried out by qualified personnel in
accordance with current regulations.
– The appliance must be connected to
the mains checking that the voltage
corresponds to the value given in the
rating plate and that the electrical
cable sections can withstand the load
specified on the plate.
– The appliance can be connected
directly to the mains placing an
omnipolar switch with minimum open-
ing between the contacts of 3 mm
between the appliance and the mains.
– The power supply cable must not
touch the hot parts and must be posi-
tioned so that it does not exceed 75°C
at any point.
– Once the appliance has been
installed, the switch or socket must
always be accessible.
Before effecting any intervention
on the electrical parts of the
appliance, the connection to the
network must be interrupted.
N.B. For connection to the mains, do
not use adapters, reducers or
branching devices as they can cause
overheating and burning.
If the installation requires alterations to
the domestic electrical system or if the
socket and appliance plug are incom-
patible, call an expert.
He should also check that the socket
cable section is suitable for the power
absorbed by the appliance.
IMPORTANT: this cooker must be
connected to a suitable double
pole control unit adjacent to the
NO DIVERSITY CAN BE APPLIED
TO THIS CONTROL UNIT.
This appliance must be earthed.
The connection of the appliance
to earth is mandatory.
The manufacturer declines all
responsibility for any inconve-
nience resulting from not
observing this condition.