Printhead Assembly Removal; Controller Board Removal; Controller Board Cage Removal - Lexmark E32x Service Manual

4500–32x 500–32x

Printhead Assembly Removal

1. Open the front cover. See
information.
2. Remove the top cover. See
information.
3. Remove the four top screws from the printhead mounting plate.
Note: There are two screws on each end of the printhead plate
used to fasten the plate to the printer left and right side frame.
4. Remove the printhead plate ground strap screw.
5. Remove the controller cage screw from the printhead mounting
plate.
6. Disconnect the printhead cables.
7. Remove the three printhead screws.
8. Remove the printhead.

Controller Board Removal

1. Open the front cover. See
information.
2. Remove the right side cover. See
page 4-3
3. Remove the controller board cover screw.
4. Disconnect cables from the controller board.
5. Remove the two parallel cable screws.
6. Remove the four controller board screws.
7. Remove the controller board.

Controller Board Cage Removal

1. Open the front cover. See
information.
2. Remove the right side cover. See
page 4-3
3. Remove the controller board. See
Removal" on page 4-4
4. Remove the three screws holding the controller board cage to
the printer side frame and remove cage from the frame.
4-4
Service Manual
y Removal
for more information.
See
for more information.
for more information.
"Front Cover" on page 4-2
"Top Cover" on page 4-2
"Front Cover" on page 4-2
"Right Side Cover
"Front Cover" on page 4-2
"Right Side Cover" on
"Controller Board
for more
for more
for more
de Cover" on
for more