D Roll Removal - Lexmark E32x Service Manual

4500–32x

D Roll Removal

1. Remove the front cover. See
more information.
2. Remove top cover. See
information.
3. Remove rear auto sheet feed cover. See
(ASF) Assembly Removal" on page 4-3 3
4. Remove right side cover. See
for more information.
5. Remove controller board cage. See
Removal" on page 4-4
6. Disconnect the printer motor cable.
7. Remove optional Tray 2 connector from bracket.
8. Remove the four main drive gear assembly screws.
9. Remove the main drive gear assembly with drive motor from
printer.
10. Depress paper feed solenoid locking tab and slide paper feed
solenoid off D–roll assembly shaft.
11. Remove the HVPS board. See
(HVPS) Removal" on page 4-5
12. Rotate the D–roll shaft retaining clips to loosen.
13. Remove the D–roll assembly. y.
4-8
Service Manual
"Front Cover" on page 4-2
"Top Cover" on page 4-2
for more information.
gear assembly screws.
VPS board. See
"Auto Sheet Feed
for more information.
"Right Side Cover" on page 4-3
"Controller Board Cage
"High Voltage Power Supply
for more information.
for
for more
Power Supply