Torques, Fits, And Clearances; General; Service Limits - Superior Vantage Engine O-360 SERIES Maintenance Manual

General

These limits provide dimensions, clearances and
interference fits necessary to maintain Superior
Vantage O-360 and IO-360 series engines.
Service limits for used parts are provided where
they have been established. If no service limits
are provided, new limits must be maintained.

Service Limits

The following information is provided in this
section:
•
Dimensional Limits are provided in Table
72-00-11.1.
•
Backlash and Clearances Limits are
provided in Table 72-00-11.2.
•
Torque Limits are provided in Table 72-
00-11.3.
•
Spring Limits are provided in Table 72-
00-11.4.
•
Crush Type Gasket Tightening Angles
are provided in Table 72-00-11.5.
NOTE: Limits followed by the letter "T" indicate
a "tight", i.e., an interference fit.
example is the fit of the valve guide in
the cylinder head. Where no "T" exists,
the fit is a clearance dimension.
© March 2006 Superior Air Parts Inc.
Maintenance Manual
O-360 and IO-360 Series Engines

TORQUES, FITS, AND CLEARANCES

An
1
Torques, Fits, and Clearances
72-00-11