500 Hour Inspection; Recommended Tbo; Recommended Accessory Replacement - Superior Vantage Engine O-360 SERIES Maintenance Manual

500 Hour Inspection

In addition to the items listed for 50 hour, and
100 hour inspections, perform the following
inspections after every 500 (+/-10) hours of
operation.
•
Magneto Inspection
Completely inspect magnetos internally including
removal, cleaning, and inspection of the ball
bearing assembly, impulse coupling, coil, contact
points, condenser, and carbon brush. Lubricate,
reassemble and reinstall magneto.
−
Perform above inspection in accordance
with Unison Industries 4300/6300 Series
Magneto Maintenance and Overhaul
Manual L-1363B, in Appendix 1, or
−
If desired, or necessary, replace with
new Unison Magneto, refer to 74-00-00
Ignition Section.
1000 Hour Inspection
In addition to the items listed for 50 hour, 100
hour, and 500 hour inspections, perform the
following inspections after every 1000 (+/-20)
hours of operation.
If the Vantage Engine is provided with an
alternator, remove
assembly and inspect brushes for excessive
wear. Replace brush assembly if brushes
extend less than .25" from edge of brush holder
case.

Recommended TBO

The Vantage Engine has a recommended TBO
of 1000 hours.
© March 2006 Superior Air Parts Inc.
Maintenance Manual
O-360 and IO-360 Series Engines
alternator field brush
Recommended Accessory
Replacement
The Vantage
recommended to be replaced at engine TBO or
other interval as specified in the appropriate
accessory sections of this manual.
6
Scheduled Inspection and Maintenance
Engine accessories
05-20-00
are