FLIR B6xx series User Manual page 111

How to set up a Follow this procedure to set up a fusion type:
fusion type
1
2
3
4
5
6
7
NOTE
When using fusion, you can also change temperature levels, and the size and position
of the infrared image frame, after you have saved the image. You can also do this in
FLIR Reporter.
Publ. No. 1558550 Rev. a557 – ENGLISH (EN) – October 7, 2011
To go to the mode selector, push the
In the mode selector, select Camera
To set up a fusion type, select Fusion in the toolbox and push the joystick.
In the Fusion box, select one of the following:
Above
■
Below
■
Interval
■
Picture in Picture
■
Push the joystick to confirm the choice.
Do one or more of the following:
If you chose Above or Below, move the joystick up or down to adjust
■
the temperature level. The temperature level is displayed as a 'flag' that
slides along the temperature scale. See the figure below.
If you chose Interval, do one or more of the following:
■
Push the joystick up/down to move the interval up/down.
■
Push the joystick left/right to increase/decrease the interval.
■
If you chose Picture in Picture, do one or more of the following:
■
Push the joystick left/right or up/down to resize the infrared image
■
frame.
Push the joystick once and then push the joystick left/right or up/down
■
to move infrared image frame.
Push and hold down the joystick for more than one second to center
■
the infrared image frame.
To deactivate Fusion, repeat Step 4 above and select Off.
15 – Working with fusion
button to the right of the joystick.
and push the joystick.
15
93