Table of Contents
Advertisement
Troubleshooting
No routers found
When the AR100 Access Wizard is started it searches for any AR100s connected
to the PC either directly or via the LAN. If it does not find any, this dialog
appears.
Figure 10-6: No Routers Found dialog
I
Make sure that the router is connected to the power supply and that the
mains power supply is switched on.
I
Make sure the Ethernet port on the PC is connected to one of the LAN
ports on the router by an Ethernet direct cable. If connected to LAN port 4,
make sure that the PC/Hub switch is in the PC position. Check that the
Link LED is on. Click Continue.
I
If the problem persists, contact your authorised Allied Telesyn distributor
or reseller.
10-7
Advertisement
Table of Contents
Troubleshooting
