Tcp/Ip Not Installed; Wizard Already Active - Allied Telesis AR100 series User Manual

Troubleshooting 10-5

TCP/IP not installed

TCP/IP is the protocol that the PC uses to communicate with the router. If this
dialog appears, you will need to install and configure TCP/IP on your PC.
Figure 10-3: TCP/IP Not Installed dialog
Follow the instructions in "Installing TCP/IP on your PC" on page 3-1, or in the
Start Here Guide.

Wizard already active

If you already have the AR100 Access Wizard running on your PC and try to
start another one, this dialog appears.
Figure 10-4: Wizard Already Active dialog
I
Exit this AR100 Access Wizard, and use the one that was already running.