Chapter 11 Safety And Statutory Information; Safety And Statutory Statements - Allied Telesis AR100 series User Manual

Chapter 11
Safety and Statutory Information

Safety and statutory statements

This information must be read prior to use of this equipment, and overrides as
appropriate any information in respect of connection and use of the
equipment. Any enquiries regarding regulatory aspects of this equipment
should be addressed to Allied Telesyn International. This product meets the
requirements of EN60950 1992 including amendments 1 through 5, Austel
AS3260 / TS001 and UL1950. / CSA C22.2 No 950.
1. Connection to mains voltage supply
This product is supplied with a power cord which incorporates a moulded
plug and has been approved for use. It must only be used with the power cord
supplied.
For continued protection against the risk of fire and shock hazard, replace fuses
only with the same type and rating.
2. Earthing
The power cord supplied with this equipment must be connected to a power
socket which provides a reliable protective earth connection.
3. Connection to ISDN network
This product is supplied with an approved patch cord, coloured Green, for
connection to the ISDN Basic Rate Network.
Caution: To reduce risk of fire use only no.26 awg or larger
telecommunications line cord if the cord supplied is not used with the
apparatus.
4. Ports for the connection of other apparatus
The following interfaces normally operate at SELV (Safe Extra Low Voltage)
levels:
I
Asynchronous (console) ports.
I
Hub ports.
Note: SELV is a voltage that does not exceed 42.4V peak a.c. or 60V d.c.