Section 4. Operation; Submerging The Cleaner - Polaris 9350 Owner's Manual

Section 4. Operation

CAUTiON
To prevent damage to the cleaner, be sure to adhere
to the following guidelines:
Remove the cleaner from the pool after the
cleaning cycle is completed and store on the caddy
out of direct sunlight or inclement weather.
Never lift the cleaner out of the pool by the floating
cable. Always use the lift feature to remove cleaner
from the pool.
Take additional care when lifting the cleaner out of
the pool. It becomes heavier when filled with water.
Always remove the cleaner from pool when super
chlorinating or adding acid.
Do not handle cleaner while it is in operation.
iMPORTANT
Always make sure the cleaner head is fully
submerged before you begin operation.
Clean the filter canister after each cleaning cycle.
Do not leave your cleaner in the pool on a permanent
basis.
At the end of each cycle, remove the cleaner from
the pool. Start at the cleaner head and untangle any
coils in the cable before storing the cleaner.
cable attached, the operating time for the current
selected cycle is displayed.
The Polaris robotic cleaner includes a safety feature
that automatically stops the cleaner if it is powered on
but not submerged in water. For pools equipped with a
beach area, this safety feature is programmed to drive
the cleaner in reverse and back into the pool when the
impeller is out of the water.
4.1

Submerging the Cleaner

1. Submerge the cleaner in the pool and remove
any air trapped inside by keeping the unit
1
Figure 15. Submerge the Cleaner Vertically
2. Ensure the unit sinks to the bottom of the pool
2
Figure 16. Cleaner Sinking to the Bottom of the
Pool
ensuring there are no kinks or coils in the
cable (Figure 17).
Figure 17. Spread Floating Cable Over the Pool
Page 9