General Cleaner Operation; Install And Submerge The Cleaner - Polaris EN27 Series Owner's Manual

|
Robotic Pool Cleaner Owner's Manual
4
General Cleaner
CAUTION
To prevent damage to the cleaner, to adhere to the
following guidelines:
• Remove the cleaner from the pool after the
cleaning cycle is completed.
• Store out of direct sunlight or inclement weather.
• Never lift the cleaner out of the pool by the
floating cable.
• Take additional care when lifting the cleaner out
of the pool. It becomes heavier when filled with
water.
• Always remove the cleaner from pool when super
chlorinating or adding acid.
• Do not handle cleaner while it is in operation
IMPORTANT
• Always fully submerge the cleaner head before
you begin operation.
• Clean the filter canister after each cleaning
cycle.
• Do not leave your cleaner in the pool on a
permanent basis.
• At the end of each cycle, remove the cleaner
from the pool.
• Start at the cleaner head and untangle any
coils in the cable before storing the cleaner.
The robotic cleaner includes a safety feature that
automatically stops the cleaner if a cleaning cycle
starts but it is not submerged in water. For pools
equipped with a beach area, this safety feature is
programmed to drive the cleaner in reverse and
back into the pool when the impeller is out of the
water.
Operation

Install and Submerge the Cleaner

1. With the control box plugged into a power
outlet, spread the floating cable across the
pool deck until you reach the middle of the
pool length.
WARNING: Do not use an extension cord
2. At the center point, submerge the cleaner in
the pool and hold in the vertical position to
release any air trapped inside.
(Figure 3).
1
Figure 3. Submerge the Cleaner Vertically
3. Ensure the unit sinks to the bottom of the
pool and does not float
(Figure 4).
2
Figure 4. Cleaner Sinking to the Bottom of the
Pool
7