Stopping The Cleaner And Removing From The Pool; Operating The Cleaner With The Remote Control (9550 Sport/P955 Only) - Polaris 9350 Owner's Manual

Page 12
4.6 Stopping the Cleaner
and Removing from the Pool
The automated Lift System makes removing the cleaner
from the pool simple. The Lift System will move the
cleaner toward the edge of the pool then drive it to the
surface for removal.
1. At the end of the cleaning cycle, or at any time
during a cleaning cycle, press
the automated lift procedure.
Press and hold the Lift System button to turn
cleaner to the left. Cleaner will keep rotating
left. Once the cleaner is oriented towards the
wall of your choice, release the button.
Press and release the Lift System button and the
cleaner will drive up the wall and to the water
line and wait to be retrieved.
The screen displays
Lift System is in operation.
NOTE: To stop the lift procedure at any time, press
2. When the cleaner is within arm's reach,
handle to remove from the water
19). Never lift the cleaner out of the pool by the
Figure 18. Remove Cleaner From Pool with handle
Figure 19. keep Cleaner Vertical to Drain Water
to begin
when the
.
use the
(Figures 18,
1
2
3
4.7 Operating the Cleaner with the
Remote Control (
with a handheld remote control stored on the cleaner
caddy next to the control unit. The remote control is
factory-synchronized to your cleaner's control unit.
ON/OFF
button
Figure 20. 9550 Sport/P955 Remote Control
Press (see Figure 20) and hold for 3 seconds.
The display shows
cleaner is now operating in remote control mode.
cleaner in the water and move directionally as shown
in Figure 21.
Forward
Stop
Turn Left
Backward
Figure 21. Remote Control Directional Commands
)
9550 Sport/P955 only
Lift System
button
to indicate the
Turn Right