General Cleaner Operation - Polaris iAquaLink CONTROL VTRX25iQ Owner's Manual

2. Grip the notched end of the floating power
cable, insert into the control box, and turn
clockwise to tighten (Figure 4).
3. Plug the control box directly into a GFCI
outlet. DO NOT use an extension cord.
X
Figure 4. Connect Floating Power Cable
NOTE: To avoid damaging the power cable, do not try to
twist the entire cable housing (see below).
X
NOTE: To avoid exposing the power cable connector pins
to water, be sure the connector is screwed in all the
way and there is no gap (see below).
X
4
General Cleaner
Operation
To prevent damage to the cleaner, be sure to
adhere to the following guidelines:
• Remove the cleaner from the pool after the
cleaning cycle is completed.
• Store on the caddy out of direct sunlight or
inclement weather.
• Never lift the cleaner out of the pool by the
floating cable. Always use the lift feature to
remove cleaner from the pool.
• Take additional care when lifting the cleaner out
X
of the pool. It becomes heavier when filled with
water.
• Always remove the cleaner from pool when
super chlorinating or adding acid.
• Do not handle cleaner while it is in operation.
X
• Always make sure the cleaner head is fully
submerged before you begin operation.
• Clean the filter canister after each cleaning
cycle.
• Do not leave your cleaner in the pool on a
permanent basis.
• At the end of each cycle, remove the cleaner
from the pool.
• Start at the cleaner head and untangle any
X
coils in the cable before storing the cleaner.
The Polaris robotic cleaner includes a safety feature
that automatically stops the cleaner if it is powered
on but not submerged in water. For pools equipped
with a beach area, this safety feature is programmed
to drive the cleaner in reverse and back into the pool
when the impeller is out of the water.
CAUTION
IMPORTANT
X
Page 7