Operation - Worx WX312 Operating Manual

Safety and operating manual
Hide thumbs Also See for WX312:
Table of Contents

Advertisement

A
B
C1
C2
Impact drill

OPERATION

NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for impact drilling in brick,
concrete and stone as well as for drilling in wood, metal
and plastic.
1. AUXILIARY HANDLE (See Fig. A)
Slide the handle onto the drill and rotate to the desired
working position. To clamp the auxiliary handle rotates
the handgrip clockwise. To loosen the auxiliary handle
rotate the hand grip anti-clockwise. Always use the
auxiliary handle.
2. INSTALLING THE DEPTH GAUGE (See Fig. B)
The depth gauge can be used to set a constant depth
to drill. To use the depth gauge, loosen the handle by
rotating the bottom section of handle anti-clockwise.
Insert the depth gauge through hole in handle. Slide the
depth gauge to required depth and tighten fully.
3. INSERTING A TOOL INTO CHUCK
(See Fig. C1, C2)
WARNING: Before any work on the machine
itself, pull the mains plug.
KEY CHUCK (1) (WX312)
Remove chuck key from key storage tab at base of drill
handle, place key into chuck, turn key anti-clockwise to
undo/loosen chuck, inset drill/tool and firmly tighten
chuck by turning key clockwise. Remove key and
replace in storage tab at base of drill handle.
(See Fig. C1)
KEYLESS CHUCK (9) (WX312.1 WX313)
To open the chuck jaws rotate the front section of the
chuck while holding the rear section. Insert the drill bit
between the chuck jaws and rotate the front section in
the opposite direction while holding the rear section.
Ensure that the drill bit is in the center of the chuck
jaws. Finally, firmly rotate the two separate chuck
sections in opposite directions. Your drill bit is now
locked in the chuck. (See Fig. C2)
4. ON/OFF SWITCH
Depress the switch to start the tool and release it to
stop your tool.
5. SWITCH LOCK-ON BUTTON (See Fig. D)
Depress on/off switch then lock-on button, release on/
off switch first and lock-on button second. Your switch
is now locked on for continuous use. To switch off your
WX3 12 WX3 12 .1 WX3 13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wx313Wx312.1

Table of Contents