Table of Contents
Advertisement
Memo :
Clip Continuous Rec cannot be used in the
0
following cases.
When [Main Menu] B [System] B [Record
0
Set] B [System] is set to "HD" or "SD", and
[Format] is set to "AVCHD"
When [Main Menu] B [System] B [Record
0
Set] B [System] is set to "HD+Web"
The following operations cannot be performed
0
while recording is paused (STBYC, yellow text).
Clip Review operation
0
(A P74 [Viewing Recorded Videos
Immediately (Clip Review)] )
Switching SD card slots
0
Switching operation mode
0
(A P18 [Operation Modes] )
Files are split into sizes of 4 GB (or 30 minutes)
0
regardless of the menu settings.
Caution :
Do not remove the SD card during recording
0
(RRECC, red text) or recording pause
(STBYC, yellow text).
To remove the SD card in the "Clip
0
Continuous" mode, press the [CANCEL/STOP]
button, check that "STBYC" (white text) is
displayed and the card slot status indicator lights
up in green before you remove the card.
When the SD card becomes full during
0
recording, recording stops and "STOP" is
displayed.
When the [POWER ON/OFF] switch is turned off
0
during recording or recording pause, recording
stops and power is cut off after a clip is
generated.
If the power is cut off due to low battery power,
0
a proper clip may not be generated.
When [WFormat]/[YFormat] in the [Main
0
Menu] B [System] B [Record Set] B [Record
Format] menu is set to "AVCHD", Clip
Continuous Rec cannot be performed.
(A P116 [ W Format ] )
(A P117 [ Y Format ] )
Frame Rec
In normal recording, when the recording stops, the
image and accompanying data from the start till the
end of the recording are recorded as one "clip" on
the SD card.
In this mode, recording starts with every press of
the [REC] button, and only the specified number of
frames is recorded.
The recording can be written to the media as a
single clip until it is stopped.
Memo :
Audio will not be recorded.
0
Until a specified amount of recordings is
0
accumulated, the file cannot be written to the
media.
If the specified amount is not reached when
0
recording is stopped, normal recording is
performed and frames are added to the ending
of the clip until the amount is reached. (Padding)
After the specified number of frames is recorded
0
and written to the media, recording will be
performed until the same number is
accumulated again.
Press [REC]
(Frame Rec starts)
Press [REC]
Press [REC]
Recording resumes
Recording resumes
Pause
Pause
Records number of frames specified in [Rec Frames]
Actual clips recorded to the media
.
Specific amount of data
1 Set [Rec Mode] to "Frame Rec".
Set [Main Menu] B [System] B [Record
0
Set] B [Rec Mode] to "Frame Rec".
(A P118 [ Rec Mode ] )
The display changes ("STBY" B "STBYM").
0
Press and hold [REC]
(Frame Rec stops)
Normal recording
Pause
(Padding data)
81
Special Recording
Advertisement
Table of Contents
