Audio Recording - JVC GY-LS300CHU Instructions Manual

Audio Recording

You can record audio from the two channels (CH1/CH2)
in synchronization with video images on this camera
recorder.
Select from the four options below to record the audio.
Built-in Microphone
0
Microphone connected to [AUX] terminal
0
Microphone connected to [INPUT1] terminal O
0
Microphone connected to [INPUT2] terminal O
0
.
Selecting Audio to Be Recorded in Each
Channel O
Select the audio to be recorded in CH1/CH2.
- Switch Setting
CH1 INT
INPUT1
CH2 INT
INPUT1
INPUT2
When CH1 or CH2 is set to "INT" and a microphone
0
is connected to the [AUX] terminal, audio is recorded
according to the setting in [Main Menu] B [A/V Set]
B [Audio Set] B [CH1 INT]/[CH2 INT].
(A P111 [ CH1 INT ] )
(A P112 [ CH2 INT ] )
Memo :
When the [AUX] terminal is not connected, [Main
0
Menu] B [A/V Set] B [Audio Set] B [CH1 INT]/[CH2
INT] is fixed at "Int. Mic L"/"Int. Mic R" respectively.
66
Audio Recording
Connected Devices
Built-in Microphone
0
Microphone connected to
0
[AUX] terminal
Microphone connected to
[INPUT1] terminal
Built-in Microphone
0
Microphone connected to
0
[AUX] terminal
Microphone connected to
[INPUT1] terminal
Microphone connected to
[INPUT2] terminal
Setting Input Channel to [INPUT1]/[INPUT2]
Select the audio to input to [INPUT1] and [INPUT2]
terminals using the [AUDIO INPUT INPUT1]/[AUDIO
INPUT INPUT2] signal selection switch.
Setting
[LINE] Use this setting when connecting to an
audio device or other equipment. The
reference input level is +4 dBu.
[MIC] Use this setting when connecting to a
dynamic microphone.
[MIC+48V] Use this setting when connecting to a
microphone (phantom microphone)
that requires a +48 V power supply.
Memo :
When "MIC" or "MIC+48V" is selected, set the
0
reference input level in [Main Menu] B [A/V Set] B
[Audio Set] B [Input1 Mic Ref.]/[Input2 Mic Ref.].
(A P112 [Input1 Mic Ref./Input2 Mic Ref.] )
Caution :
When connecting a device that does not require a
0
+48 V power supply, make sure that it is not set to
the "MIC+48V" position.
When the [AUDIO INPUT INPUT1]/[AUDIO INPUT
0
INPUT2] signal selection switch is set to "MIC", make
sure that a microphone is connected to the [INPUT1]/
[INPUT2] terminal. If you increase the recording level
when a microphone is not connected, noise from the
input terminal may be recorded.
When a microphone is not connected to the
0
[INPUT1]/[INPUT2] terminal, set the [AUDIO INPUT
INPUT1]/[AUDIO INPUT INPUT2] signal selection
switch to "LINE" or adjust the volume with the [CH-1]/
[CH-2] recording level adjustment knob.
Description