Connecting Wires To Terminals - Kenwood DPX-6020 Instruction Manual

Connecting Wires to Terminals

KENWOOD disc changer control input
NOTE
To connect the Disc changer,
consult your Disc changer manual.
When using the optional power
amplifier, connect to its power
control terminal.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
To "EXT.AMP.CONT." terminal of the amplifier
having the external amp control function.
To car light control switch
Ignition key
switch
Car fuse
box
(Main
fuse)
Battery
+ –
2WARNING
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
Front left output (White)
Front right output (Red)
Rear right output (Red)/
Non-fading right output (Red)
P.CONT
Power control wire
(Blue/White)
ANT
Motor antenna control wire
CONT
(Blue)
EXT.
External amplifier control wire
CONT.
(Pink / Black)
ILLUMI Automatic illumination/Dimmer
control wire (Orange)
Ignition wire (Red)
ACC
Battery wire (Yellow)
Car fuse box
Ground wire (Black) - (To car chassis)
10
Wiring harness
2CAUTION
When only two speakers are being connected to the system,
connect the connectors either to both the front output
terminals or to both the rear output terminals (do not mix
front and rear). For example, if you connect the + connector
of the left speaker to a front output terminal, do not connect
the - connector to a rear output terminal.
— 38 —
Rear left output (White)/
Non-fading left output (White)
FM/AM antenna input
Fuse
(10A)
(Accessory#)
White/Black
To front left
–
speaker
+
FRONT•L
White
Gray/Black
– To front right
speaker
FRONT•R +
Gray
Green/Black
To rear left
–
speaker
+
REAR•L
Green
Purple/Black
– To rear right
speaker
+
REAR•R
Purple